Komatsu — LOADING, UNLOADING WORK

. OPERATION TRANSPORTATION TRANSPORTATION LOADING, UNLOADING WORK WARNING 3 - 118 When transporting the machine, o bserve all related laws and regulations, and be careful to a TRANSPORTATION PROC A t railer should be used for transp Make sure the ramp has sufficient width, length and thickness to enable the machin e to be safely loa ded and unloaded If the ramp sags appreciably, reinf When loading and unloading the m achine, park the trailer on a flat firm roadbed. Kee p a fairly long dis tance between th e road shoulder and the machine. rriage to prevent the machine from slipping to the side on slopes. nd free of grease, oil, ice and loose materials.

Remove the mud from the underca rriage to prevent the machine from slipping to the side on slopes. Be sure the ramp surface is clean a nd free of grease, oil, ice and loose materials. Never change the direction of trave l when on the ramps. If it is necessary to change direction, drive of f the ramps and c orrect the direction, then drive on to the r amps again. When loading or unloading, alway s use ramps or a platform and carry out the operations as LOADING ground only. the edge of a road. 1. Load and unload on firm level Maintain a safe distance from 2.

Apply the trailer brakes secur tires to prevent the trailer from Set left and right ramps equally spaced to the left a Make angle of installation ramps bend a large am machine, put blocks under bending. 1. Load and unload on firm level Maintain a safe distance from 2. Apply the trailer brakes secur ely, then put blocks (1) under the tires to prevent the trailer from moving. (2) parallel to each other and Set left and right ramps nd right of center (3) of the trailer. (4) a maximum of 15°. If the ount under the weight of the the ramps to prevent them from 3. Set parking brake lever to the FREE position (F). 4. Set the transmission in the 1s t gear and run the engine at low idle.

the ramps and drive slowly. 5. Set the travel direction toward 6. The center of gravity of the machine shifts suddenly at the border between the ramps a unbalanced and becomes da border slowly. nd trailer, and the machine is ngerous. Accordingly, pass the ified position on the trailer. 7. Stop the machine at the spec