. OPERATION TRANSPORTATION After removing, cover the washer hoses with a vinyl bag to prevent any dirt or dust from entering. Before removing the cab, measure the clearance between the cab and each lever (joystick and blade control lever, etc.). Note the measurements to use as a standard when installing the cab again. INSTALLATION OF CAB (Machine equipped with cab) (If equipped) Install the cab parts in the opposite order to removal. Connect all parts that were disconnected. Install the cab mounting bolts as follows. 1. Lower the cab slowly on top of the floor frame. 2. Align the cab with the floor frame, then install bolts and washers in holes (A) - (U). Do not screw the bolts in fully.
Screw them in 3 or 4 turns. 3. Tighten the bolts in holes (N) - (U) fully. Tighten in the order (N), (U), (Q), (R), (O), (T), (P), (S). 4. Tighten the bolts, (A) to (M), completely. If there are any unclear points about removing or installing the cab, please contact your Komatsu distributor. 3 - 123 REMOVAL OF CAB cab) (If equipped) (Machine equipped with cab) ( If equipped) If it is necessary to remove the cab f or transportation, disconnect the washer h removing the oses, cab wiring, and washer motor wiring before cab. 1. Pull the grommet portion in towards the cab from the hole in the machine cover, then remove. 2.
Disconnect 4 washer hoses and the wiring (single wires x 2, 4-pin plug x 1). machine cover, then remo . Disconnect 4 washe hose 4-pin plug x 1). (1) Washer tube Red-Right door Blue-Left door Black-Rear window Colorless-Front window (2) Power source of cab 5R-ACC power source of cab 2R-Back up power source (3) 4-pin socket For washer motor