Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE 4 - 22 1. Stop the engine and close th e valve (1) of corrosion resistor cartridge.(Only machines equ ipped with corrosion resistor) remove it. 2. Turn radiator cap (2) slowly to 3. Set a container to catch the co bottom of the radiator and dr cooler and drain plugs (5) at and drain off the cooling wate olant, open drain valve (3) at the ain valve (4) at the bottom of oil the both sides of cylinder block, r. When opening drain plug (5), 4. carry out after removing a fen After draining, close up drain pour in clean water up to the der cover (6). valve (3), (4) and plugs (5) and vicinity of the water filler.

h water, start the engine, run at 5. When the radiator is filled wit low idling. Continue to run the engine at low idling and flush the radiator for 10 minutes. 6. Stop the engine and open dra in valves (3) and (4) to drain the water. 7. After draining the water, clean the cooling system with cleaning agent. For the cleaning method, see the instructions for the cleaning agent. 8. After flushing, open drain valv e (3), (4) and plug (5), completely drain all the water, then close the drain valve (3), (4) and plug (5). Replace the corrosion resist or, then open valve (1). (Only sion resistor) 9.

machines equipped with corro For details on the corrosion re sistor replacement method, see "REPLACE CORROSION R 4-68)". ESISTOR CARTRIDGE (PAGE ter filler up to the filler port. n the coolant, run the engine at 10. Add city water through the wa 11. To remove the air contained i low idle for 5 minutes, then ru n for a another 5 minutes at high idle. (When doing this, leave t he water filler cap OFF.) 12. Stop the engine, wait for appro x. 3 minutes, then add city water to near the mouth of the filler port, and tighten caps (2).