. MAINTENANCE SERVICE PROCEDURE 4 - 37 REPLACE ALTERNATOR DRIVE BELT 1. L to 2. R 1. L oosen nuts (1) and ( 4) and bolt (2), then move altern ator (3) adjust. eplace the V-belt. When adjusting t he V-belt, do not push alternator (3) directly with the ba Tighten nut (1) to te nut (4). The stand (0.7 - 0.8 in) when approx. 10 kg mid and alternator pull r. Use nut (1). nsion the V-belt, then tighten bolt (2) and ard deflection for the V-belt is 19 - 21 mm pressed with a thumb with a force of way between air compressor pulley (5) ey (3). mb with a f orce of CLEAN AND CHECK HYDRAULIC COOLER FINS If the hydraulic cooler fins are clogged or there i s dirt caugh t in the fins, clean and check the 1.
O pen the inspection c 2. U se compressed air to remove the mud leaves logging the hydraulic cooler fins. Steam or water may b e used stead of compresse REMARK Chec k the hydraulic coole r hoses. If any hose i s cracked or hardened by age, replace with a new hose. Also check and t ighten all loose hose clamps.