Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE CHECK AND ADJUST AIR CONDITIONER CHECK LEVEL OF REFRIGERANT(GAS) WARNING and the sight 4 - 40 CHECK TENSION OF COMPR If th e belt is loose, it will sli p and the cooling effec t wil l be redu ced. From time to time, p ress a point midway between the altenator drive pulley and compressor pulley wit h your fin ger and check that the t Wh en the belt is new, ther e will be initial elongation, so alwa ys adjust again after 2 o For check, adjust tension of belt, see "REPLAC LTERNA W hen handling refriger egulations.

he refrigerant used in th ant gas, always follow local laws e cooler is colorless and odorless and r T n h o ot harm the atmosphere, but if the liquid gets into your eyes or on ands, it may cause loss o f the refrigerant circuit. f sight or frostbite, so never loosen an If th e level of the refrigera nt (gas) is low, the cooling effect w reduced. Run the engine at high idle, and check t he flow o refrigerant gas (R134a) in the refrigerant circuit through the glas s (2) (inspection windo w) of the receiver (1) whe n the coo running at high speed. are included in the flow cluded in the flow continuously) nsparent ( A) Correct: No bubbles ( B) Low: Bubbles are in (bubbles pass ( C) None:

Colorless, tra REMARK When there are bubble s, the refrigerant gas level is low, so contact your refrigerant dealer to have refrigeran frigeran a dded. If the air conditi oner is run with the refrigerant gas level low, it will cause d amage to the compr New Freon R134a is u sed as the refrigerant. Charge amount of air con ditioner refrigerant (gas): 1