. MAINTENANCE SERVICE PROCEDURE Fuel control (1 place) (1)Decelerator pedal Brake pedal (1 place) Brake rod lever (1 place) 4 - 44 BLEEDING AIR IN HYDRAULIC SYSTEM See "OPERATIONS A ND CHECKS A FTER STARTING ENGINE Sinc e the engine mus t be started and the bla de must be operated, see OPE NOTICE If the engine is run at high speed immediatel y after startup or a cy linder is pushed up to its stroke en d, air take n inside the c ylinder may cause damage to th 1. Bleeding air from 1) Run the engin e at low idle, and exten d and retrac t each cylinder 4 to 5 times, ta king care that a cylin der is not moved to t he end of its stroke. (S top the cylin der approx.
100 m m (3.9 in) s hort of its stroke end 2) Next, operate each cylinder 3 t o 4 tim es to the en d of its stroke. 3) Finally, operat e each cylinder 4 to 5 t imes to the end of its stroke to c ompletely remove t he LUBRICATING uipment to the ground, then stop the engine. 1. Lower the work eq uipment to the g round , then stop t he engine 2. Using a grease pu mp, pump in grease th rough the g rease fittings shown by arrows 3. After greasing, wi pe off any old grease th at was push ed out.