Komatsu — EVERY 500 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE REPLACE FUEL FILTER CARTRIDGE WARNING Container to catch the oil Prepare a filter wrench 4 - 59 After the engine has been operated, all parts are at high temperature, so do not replace the filter im mediately. Wait for all parts to cool down before starti ng the operation. d inside the engine fuel piping system when the engine is running. High pressure is generate When replacing the filter, replacing the filter. wait for at least 30 seconds after stopping the engine to let the interna l pressure go down before me close. Do not bring any fire or fla NOTICE Genuine Komatsu fuel filt er cartridges use a special filter that has highly efficient filtering ability .

When replacing the filter cartridge, always use a ge nuine Komatsu part. The HPI fuel injection syst em used on this machine consists of more precise parts than the conve ntional injection pump and nozzle. If any part other than a ge system. Always avoid usi nuine Komatsu filter cartridge is used, dust or dirt may get in and cause problems with the injection ng substitute parts. When carrying out inspect ion or maintenance of the fuel system, pay more attention than normal t o the entry of dirt. If dirt is stuck to any part, use fuel to wash it off completely. 2. Close fuel supply valv rear of the machine. 3. Using a filter wrench, on remove it. 4.

Clean the filter holder, coat the packing surfa holder. NOTICE 2. Close fuel supply valv e (2) at the bottom of the fuel tank at the turn filter cartridge (1) counterclockwise fill the new filter cartridge with clean fuel, ce thinly with oil, then install to the filter an fuel and be careful not to let any dirt or dust er area is the clean side, so be careful not to When filling with fuel, use cle get in. In particular, the cent let dirt or dust get in. 5. When installing, tighte 1/2 to 3/4 of a turn. If the filter cartridge is filter cartridge is too lo 5.

When installing, tighte n until the packing surface contacts the seal surface of the filter holder, then tighten it up tightened too far, the packing will be damaged and this will lead to leakage of fuel. If the ose, fuel will also leak from the packing, so always tighten to th e correct amount.