. MAINTENANCE SERVICE PROCEDURE REPLACEMENT 4 - 63 CHECK, REPLACE FAN BELT Check t he V-belt, and replace the V-belt if the conditio n is as follows. If the V-belt is in contact wi th the bottom of the pulle y groove. If the V-belt is worn and ha s sunk belo w the outside diameter of the pulley. If the V-belt is cracked or p 1. Loosen stopp er bolt (1). After loosenin g it so t hat th e tip o f the bolt is l evel w ith surface ( A) of tension bracke t (2), r emov e the old fan belts. 2. Temporarily i nstall the 3 n ew fan belts 3. Tighten stopp er bolt (1) u ntil it contact s surface (B) bracke t (2). 4. Afte r it conta tighten lockn ut (3) to lock it in position Tightening to rque of bolt:
7 Nm {25 - 3 1.5 Always repla ce the V-belt s as a set (3 belts).