Maintenance—Every 250 Hours Clean Primary Air Cleaner Element - 850DLC 1. Unlock clamps (2), and pull air cleaner cover outward to remove. 2. Remove primary element (3). TX1002271A –UN–05JAN06 3. Tap element with the palm of your hand, NOT ON A HARD SURFACE. CAUTION: Prevent possible injury from flying chips if compressed air is more than 210 kPa (2.1 bar) (30 psi). Reduce compressed air to less than 210 kPa (2.1 bar) (30 psi) when using for cleaning purposes. Clear area of bystanders, guard against flying chips, and wear personal protection equipment including eye protection. TX1002272A –UN–05JAN06 4. If this does not remove dust, use compressed air under 210 kPa (2.1 bar) (30 psi). 5.
Direct air up and down the pleats from inside to outside. Be careful not to make a break in the element. IMPORTANT: A damaged or dirty element may cause engine damage. 2—Clamps (3 used on each Air Cleaner) 3—Primary Air Cleaner Element Install a new primary element: 1. If the element shows damage. 2. If element will not clean. 3. After 1000 hours service or annually. Install a new secondary element: 1. If the primary element is damaged and needs to be replaced. 2. If the element is visibly dirty. 3. After 1000 hours service or annually. DO NOT clean a secondary element. Install a new element carefully centering it in the canister. 6. Inspect element and gasket for damage.
If element is damaged, install a new element (See Section 3-8). Continued on next page DW90712,0000045 –19–31OCT06–1/2 3-6-9 010609 PN=153