John Deere 450DLC, 650DLC, and 850DLC Excavators — Operational Checks—Key Switch ON, Engine ON Checks

4-6-16 010609 PN=280 Miscellaneous—Operational Checkout Hydraulic Oil Tank Pressurization Check 1—Hydraulic Oil Tank Pressure Release Button 2—Hydraulic Oil Tank Cover Raise boom to full height, then lower boom to ground. Slowly depress pressure release button on hydraulic oil tank cover. LISTEN: Is air heard escaping from the pressure release TX1000859 –UN–01DEC05 button on hydraulic oil tank cover? IMPORTANT: The pressurized oil tank creates pressure at the inlet to the hydraulic pumps. If tank cover does not seal, hydraulic pumps could cavitate and be damaged. YES: Go to next check. NO: Replace hydraulic oil tank cover.

– – –1/1 Control Lever Pattern Check—Backhoe Pattern 1—Engine Speed Dial 2—Auto-Idle Switch 3—Power Mode Switch CAUTION: Machine will move during this check. Make sure area is clear, and large enough to operate the machine. Locate pilot control lever pattern decal on right window. TX1000170 –UN–10NOV05 Become familiar with excavator and backhoe pattern functions. Turn engine speed dial (1) to slow idle (L) position. Place pilot shutoff lever (A) to UNLOCKED position (forward). Slowly actuate pilot control levers to all positions shown on decal. LOOK: Do functions operate as expected in backhoe pattern? YES: Go to next check. NO: See your authorized dealer. – – –1/1