Axle Shaft, Bearings, and Reduction Gear 22. Remove parts (1—4) as shown. 23. Inspect second idler pinion gear (3) and bearing cones (1 and 4). Replace as necessary. 24. Install bearing cones (1 and 4) onto second idler pinion gear (3). T118988 –UN–14DEC98 1—Bearing Cone 2—Second Idler Ring Gear 3—Second Idler Pinion Gear 4—Bearing Cone Continued on next page CED,TX03399,5970 –19–24MAR00–11/26 TM1859 (14JUL04) 02-0250-5 700H Crawler Dozer 071404 PN=135 17. Remove parts (1—6) as shown. 18. Inspect final drive input gear (4) and bearing cones (3 and 5). Replace as necessary. 19. Install bearing cup (6) into housing half (7). –UN–18AUG00 20.
Install bearing cones (3 and 5) onto final drive input gear (4). 51 21. Install bearing cup (2) and snap ring into housing. T1331 Check end play. Final Drive—Specification 1—Snap Ring Input Shaft—End Play........................... 0.076—0.432 mm (0.003—0.017 2—Bearing Cup in.) 3—Bearing Cone 4—Final Drive Input Gear 5—Bearing Cone 6—Bearing Cup 7—Housing CED,TX03399,5970 –19–24MAR00–10/26 02 0250 5