Remove and Install Single Lever Control (SLC) With Speed In Grip Controls Linkage 1. Turn battery disconnect switch to the OFF position. NOTE: Mark electrical connectors to aid in assembly. 2. Disconnect rotary sensors (2 and 4) and neutral start switch (3). 3. Disconnect reverse ratio switch (1) connector. 4. Disconnect harness connectors (5) to transmission speed control switch and horn button. T124637B –UN–17SEP99 03 0315 5. Remove four cap screws and single lever control assembly. 8 6. Install single lever control using four cap screws. 7. Connect reverse ratio switch connector. SLC With Speed In Grip Shown 8. Connect rotary sensors (2 and 4) and neutral start switch (3). 9.
Turn battery disconnect switch to the ON position. 10. Adjust single lever control. (See Single Lever Control (SLC) Adjustment in Operation and Test Manual, Group 9026-20.) 11. Calibrate transmission controller. (See Calibrate Transmission Controller in Operation and Test Manual, Group 9015-20.) 1—Reverse Ratio Switch 2—Steer Sensor 3—Neutral Start Switch 4—F-N-R Sensor 5—Harness to Transmission Speed Switch and Horn T124610B –UN–17SEP99 SLC with speed in grip shown CED,TX03399,5976 –19–24MAR00–1/1 TM1859 (14JUL04) 03-0315-8 700H Crawler Dozer 071404 PN=172