John Deere 700H Crawler Dozer — Disassemble and Assemble

Controls Linkage TM1859 (14JUL04) 03-0315-17 700H Crawler Dozer 071404 PN=181 IMPORTANT: Drive bearing from lettered side of bearing only. 25. Install yoke pivot pin bearing (3) using JDG1303-4 Driver Disk and JDG1303-5 Driver Rod. Drive bearing until driver disk is fully seated on yoke, this will set bearing to proper depth. –UN–11MAY99 26. Repeat step 28 for installing other yoke pivot pin bearing. T121380B IMPORTANT: Lip side of seal must face away from bearing. 27. Apply petroleum jelly to seal and install seal (5) on JDG1303-7 Driver Disk (4) with lip of seal facing toward driver disk. 28. Place seal and driver disk square on yoke.

Insert JDG1303-5 Driver Rod and drive seal until driver disk is fully seated on yoke. –UN–11MAY99 29. Repeat steps 30 and 31 for installing other yoke pivot pin seals. T121381B 1—JDG1305-5 Driver Rod 2—JDG1303-4 Driver Disk 3—Yoke Pivot Pin Bearing (2 used) 4—JDG1303-7 Driver Disk 5—Yoke Pivot Pin (2 used) Continued on next page CED,TX03399,5977 –19–24MAR00–14/28 03 0315 17