Controls Linkage 37. Install rod on detent plate, if removed. Tighten nut to specifications. Single Lever Control—Specification Detent Plate Rod Ball Joint Nut— Torque 19 (14 lb-ft) (168 lb-in.) ........................................................... 38. Install cam (5) on detent shaft and install spring pin. T119651B –UN–18JAN99 NOTE: When driving pin in detent plate, support assembly to prevent damage to bearings and seals. 39. While holding detent plate (2) and spacers (4) in place, install detent shaft (3) as shown with spring pin holes for plate and cam in line. Install spring pin (1) in detent plate.
03 0315 1—Spring Pin 2—Detent Plate 3—Detent Shaft 4—Spacers (2 used) 5—Cam 20 CED,TX03399,5977 –19–24MAR00–17/28 NOTE: Align pin bore in bearing block and sensor shaft. 40. Install bearing block (1) and steer sensor shaft (2). 1—Bearing Block 2—Steer Sensor Shaft T119650B –UN–19JAN99 CED,TX03399,5977 –19–24MAR00–18/28 NOTE: Care should be taken to avoid damaging bearing block, bearings and seals. 41. Install lever assembly, and using a 1/4 in. punch with rounded edges, drive pivot pin (1) into bracket assembly. Pin should protrude equally on both ends. T119649B –UN–19JAN99 42. Install seal plugs.
1—Pivot Pin TM1859 (14JUL04) 03-0315-20 700H Crawler Dozer Continued on next page CED,TX03399,5977 –19–24MAR00–19/28 071404 PN=184