John Deere 700H Crawler Dozer — Remove and Install

Control Linkage 1—Brake Pedal 5—Washer (5 used) 9—Brake Support 13—Rotary Sensor 2—Needle Roller Bearing (4 6—Nut 10—Spring Pin 14—Cap Screw (2 used) used) 7—Spring Pin 11—Washer 15—Cap Screw (5 used) 3—Chain Link 8—Torsion Spring 12—O-Ring 16—Nut 4—Shoulder Bolt 1. Disassemble and assemble replace parts as necessary. surface the rotary sensor (13) will not be able to assemble correctly. Install bearing on the "inner" surface of the pedal support. 2. Apply grease to all bearings before installing. 3. Press bearings (2) into each end of brake pedal (1) until flush to 1 mm (0.04 in.) recessed. 5.

Press bearing (2) into the right ear of the pedal support (9) with bearing flush to 1 mm (0.04 in.) recessed from the "inner" surface of ear. Brake Pedal—Specification Bearings—Distance Flush to 1 mm (0.04 in.) recessed ...................................... Pedal Support—Specification Right Support Pedal Bearing— Distance Flush to 1 mm (0.04 in.) recessed from the inner surface of right ear ........................................................ 4. Press bearing (2) into left ear of pedal support (9) flush to 1 mm (0.04 in.) recessed from outer side of casting. 6. Apply thread lock and sealer (medium strength) to threads of cap screws (14). Tighten cap screws.

Pedal Support—Specification Left Pedal Support Bearing— Distance Flush to 1 mm (0.04 in.) recessed from outer surface of left ear ........................................................ 7. Adjust pedal to brake valve linkage. (See Brake Pedal to Brake Valve Linkage Adjustment in Operation and Test Manual, Group 9026-20. IMPORTANT: If right hand bearing on the pedal support is pressed flush with "outer" CED,OUTX547,129 –19–08APR99–2/2 TM1859 (14JUL04) 11-1115-3 700H Crawler Dozer 071404 PN=327 Remove and Install Park Lock Linkage 1. Lower all equipment to ground and stop engine. 2. Turn battery disconnected switch off. –UN–09DEC98 3. Remove four cap screws (1) and instrument panel (2). 4.

Remove lower dash panel (3). T118806B 1—Cap Screw (4 used) 2—Instrument panel 3—Lower Dash Panel Continued on next page CED,TX03399,6025 –19–28MAR00–1/4 11 1115 3