Remove and Install Alternator Alternator, Regulator and Charging System Wiring IMPORTANT: Turn battery disconnect switch to "OFF" to prevent accidental grounding of alternator wiring leads. 1. Turn battery disconnect switch to "OFF" position. 2. Remove right side engine shield. Release tension on fan belt and remove fan belt from alternator pulley. T130847B –UN–21JUL00 3. Disconnect wire leads (2, 3, 4 and 6) from alternator. 4. Remove cap screws (1 and 5). 5. Remove alternator and make necessary repairs (See CTM77, Alternator). 1—Cap Screw 2—Terminal W 3—Terminal D+ 4—Terminal B+ 5—Cap Screw 6—Ground Terminal 6. Install alternator. Install and tighten cap screws (1 and 5). 7.
Connect wire leads (2, 3, 4 and 6). Tighten battery terminal nut wire lead (3) and (4). Alternator—Specification Battery Terminal Nut Wire Lead (B+)—Torque 7.75 ± 0.8 (69 ± 7 lb-in.) ............................................... Battery Terminal Nut Wire Lead (D+)—Torque 2.75 ± 0.3 (24 ± 3 lb-in.) ............................................... 8. Install fan belt on alternator pulley. 9. Install right side engine shield. 10. Turn battery disconnect switch to "ON" position. CED,TX03399,5013 –19–14APR99–1/1 16 1672 2 TM1859 (14JUL04) 16-1672-2 700H Crawler Dozer 071404 PN=358