Heating and Air Conditioning 4. Remove four cap screws (A) from around seat box bottom. 5. Remove shoulder cap screws (C) from seat box under armrest (B) on both sides of seat. 6. Remove two cap screws from knee pad (E) on both sides of seat (if equipped). T116758B –UN–03SEP98 7. On units equipped with rear screen or cab, tilt back of seat forward. 8. Tilt seat up as far as possible with jack screw (D) located in left rear corner of seat box. 9. Disconnect blower wire connector and heater hoses. 10. Remove heater/blower assembly T116757B –UN–21AUG98 11. Remove parts as necessary. 12. Assemble parts and lower seat. 13. Install floor access plate and floor mat. 14. Fill engine coolant.
(See Operator’s Manual.) The approximate capacity of engine coolant is 19.4 L (20.5 qt). A—Cap Screws Around Seat Box Bottom (4 used) B—Armrest C—Shoulder Cap Screws (2 used) D—Jack Screw E—Knee Pad T116728B –UN–21AUG98 TM1859 (14JUL04) 18-1830-43 700H Crawler Dozer CED,TX03399,5024 –19–16NOV00–3/3 071404 PN=487 1—Heater Base 5—Blower Motor Bulkhead 9—Backing Plate 12—Cap Screw (2 used) 2—Heater Assembly 6—Heater Core 10—Cap Screw (10 used) 13—Switch 3—Heater Tray 7—Support 11—Blower 4—Gasket Kit 8—Wiring Harness (Not Shown) with Grommet 1. Drain engine coolant. The approximate capacity of 3. For machines equipped with a toolbox, pull out engine coolant is 19.4 L (20.5 qt).
drawer and remove cap screw holding toolbox in place. Remove toolbox. 2. Remove floor mat and floor access plate. CED,TX03399,5024 –19–16NOV00–2/3 18 1830 43