Hydraulic System TM1859 (14JUL04) 21-2160-5 700H Crawler Dozer 071404 PN=513 14. Cut tie band from hydraulic lines, if necessary for access. 15. Disconnect lines (1 and 2). Close all openings using caps and plugs. –UN–19JAN99 16. Install lifting strap around pump. Connect strap to the end of DFT1132 Removal and Installation Tool. (See DFT1132 Hydrostatic Motor T119661B and Hydraulic Pump Removal and Installation Tool in Section 99 for instruction to make tool.) 1—Input Line (Hydraulic Pump-to-Reservoir) CAUTION: The approximate weight of the 2—Line (Hydraulic Pump-to-Hydraulic Control hydraulic pump with drive thru approximately Valve Inlet) 36 kg (79 lb).
3—Cap Screws (4 used) 4—DFT1132 Tool Hydraulic Pump—Specification Hydraulic Pump—Weight............................... 36 kg (79 lb) (Approximate) 17. Remove four mounting cap screws (3) and carefully remove hydraulic pump from left side of machine. 18. Install hydraulic pump and tighten mounting cap screws to specifications. Hydraulic Pump—Specification Hydraulic Pump Mounting Cap Screws—Torque.......................................................... 140 N•m (103 lb-ft) 19. Connect inlet and outlet lines to hydraulic pump. 20. Return any lines moved for access to original position, and install tie bands. 21. Install heater and connect heater hoses, if equipped. 22.
Lower seat and secure floor plate. 23. Install tool box (if equipped), knee pads and armrests. 24. Install floor access plate and mat. 25. Fill hydraulic reservoir. The approximate capacity of hydraulic reservoir is 51 L (13.5 gal). (See Operator’s Manual.) Continued on next page CED,TX03399,6066 –19–16NOV00–3/4 21 2160 5