Hydraulic System T156547 –UN–02JUL02 21 2160 12 Thru Drive Hydraulic Pump (S.N. 894372— ) 1—Matched Gear Set 6—Stub Shaft Retainer 11—Channel Seal (2 used) 16—Seal 2—Gasket Seal (2 used) 7—Stub Shaft Assembly 12—Thrust Plate (2 used) 17—Seal 3—Stub Shaft Housing 8—Set Screw (2 used) 13—Center Gear Housing 18—Seal Retainer 4—Stud (3 used) 9—Cap Screw 14—Alignment Pin (4 used) 19—O-Ring 5—Nut (6 used) 10—Backing Seal (2 used) 15—Lower Gear Housing 20—Retainer Ring Apply clean hydraulic oil on all internal parts. 20. Install thrust plate/seal assemblies on the matched gear set with the seals facing away from the gear and sealing toward the pressure side of the pump as shown. 15.
Install stub shaft assembly (7) in housing (3), seating the bearing in the bottom of housing. 16. Install stub shaft retainer (6) in housing and tighten so there is zero end play on stub shaft assembly. 21. Assemble center gear housing (13), and lower gear housing (15). 22. Assemble stub shaft housing (3) to center and lower gear housings. 17. Install and tighten set screws (8). 18. Install matched gear set (1) in center housing (13). 23. Install studs with nuts and cap screws and tighten to specification. 19. Install channel seals (11) in thrust plates (12). Install backing seals (10) into step of channel seals.
TM1859 (14JUL04) 21-2160-12 700H Crawler Dozer Continued on next page TX,3260,SS2327 –19–22JUL02–6/7 071404 PN=520