Hydraulic System TM1859 (14JUL04) 32-3260-15 700H Crawler Dozer 071404 PN=567 Disassemble and Assemble Auxiliary Control Valve Section 1 12 13 13 2 3 4 11 7 6 5 7 –UN–17AUG00 10 8 9 9 8 T132750 T132750 1—Valve Housing 5—Spool End Screw 8—Wiper Seal (2 used) 11—Spool 2—Cap Screw (2 used) 6—Spring Seat (2 used) 9—Lip Seal (2 used) 12—Load Check and Spring 3—Cap 7—Retaining Plate (2 used) 10—Screw (2 used) 13—Shut-Off Plug (2 used) 4—Centering Spring IMPORTANT: Spool MUST be installed into the Remove and Install Wiper Seals and Lip Seals on valve housing the same way it was Hydraulic Control Valve Sections in this group.) removed for proper operation of the hydraulic function. 5.
Install parts (4—7) on spool. Clean threads of spool (11), and spool end screw (5) and apply cure 1. Remove parts (2, 3, 7 and 10) to remove spool (11) primer. Apply thread lock and sealer (high strength) from valve housing (1). on spool end screw. Install and tighten to specifications. 2. Using a protective cover or wooden blocks, put spool in vise. Remove spool end screw (5), spring Hydraulic Control Valve—Specification (4), and spring seats (6). Auxiliary Valve Spool End Screw—Torque..................................... 9.5 ± 0.1 N•m (84 ± 12 lb-in.) 3. Inspect parts for wear or damage. Replace all 6. Coat spring (4) with grease. O-rings and seals. 7. Assemble remaining parts.
Tighten cap screws (2), 4. Put clean hydraulic oil on spool and install spool screws (10) and plugs (13) to specifications. into valve housing. Install lip seals (9) and wiper seals (8) using JDG734 Seal Installation Tool. (See Continued on next page CED,TX03399,6079 –19–31MAR00–1/2 32 3260 15