John Deere 700H Crawler Dozer — Disassemble and Assemble Angle Section

Hydraulic System TM1859 (14JUL04) 32-3260-17 700H Crawler Dozer 071404 PN=569 Disassemble and Assemble Angle Control Valve Section –UN–14DEC98 T118815 1—Valve Housing 5—Centering Spring 8—Retaining Plate (2 used) 11—Screw (2 used) 2—Cap Screw (2 used) 6—Spool End Screw 9—Wiper Seal (2 used) 12—Spool 3—Spacer 7—Spring Seat (2 used) 10—Lip Seal (2 used) 13—Load Check and Spring 4—Cap IMPORTANT: Spool MUST be installed into the Remove and Install Wiper Seals and Lip Seals on valve housing the same way it was Hydraulic Control Valve Sections in this group.) removed for proper operation of the hydraulic function. 5. Install parts (3, 5—8) on spool.

Clean threads of spool (12), and spool end screw (6) and apply cure 1. Remove parts (2, 4, 8 and 11) to remove spool (12) primer. Apply thread lock and sealer (high strength) from valve housing (1). on spool end screw. Install and tighten to specifications. 2. Using a protective cover or wooden blocks, put spool in vise. Remove spool end screw (6), spacer Hydraulic Control Valve—Specification (3), spring (5), and spring seats (7). Angle Valve Spool End Screw—Torque..................................... 9.5 ± 0.1 N•m (84 ± 12 lb-in.) 3. Inspect parts for wear or damage. Replace all 6. Coat spring (5) with grease. O-rings and seals. 7. Assemble remaining parts. Tighten cap screws (2) 4.

Put clean hydraulic oil on spool and install spool and screws (11) to specifications. into valve housing. Install lip seals (10) and wiper seals (9) using JDG734 Seal Installation Tool. (See Continued on next page CED,TX03399,6080 –19–31MAR00–1/2 32 3260 17