Hydraulic System TM1859 (14JUL04) 32-3260-19 700H Crawler Dozer 071404 PN=571 Disassemble and Assemble Tilt Control Valve Section 1 13 2 3 4 5 8 12 6 8 7 11 –UN–21NOV00 10 9 9 10 T132771 T132771 1—Valve Housing 5—Centering Spring 8—Retaining Plate (2 used) 11—Screw (2 used) 2—Cap Screw (2 used) 6—Spool End Screw 9—Wiper Seal (2 used) 12—Spool 3—Spacer 7—Spring Seat (2 used) 10—Lip Seal (2 used) 13—Load Check and Spring 4—Cap IMPORTANT: Spool MUST be installed into the 5. Install parts (3, 5—8) on spool. Clean threads of valve housing the same way it was spool (12), and spool end screw (6) and apply cure removed for proper operation of the primer.
Apply thread lock and sealer (high strength) hydraulic function. on spool end screw. Install and tighten to specifications. 1. Remove parts (2, 4, 8 and 11) to remove spool (12) from valve housing (1). Hydraulic Control Valve—Specification Tilt Valve Spool End Screw— Torque................................................... 9.5 ± 0.1 N•m (84 ± 12 lb-in.) 2. Using a protective cover or wooden blocks, put spool in vise. Remove spool end screw (6), spacer 6. Coat spring (5) with grease. (3), spring (5), and spring seats (7). 7. Assemble remaining parts. Tighten cap screws (2) 3. Inspect parts for wear or damage. Replace all and screws (11) to specifications. O-rings and seals. 4.
Put clean hydraulic oil on spool and install spool into valve housing. Install lip seals (10) and wiper seals (9) using JDG734 Seal Installation Tool. Continued on next page CED,TX03399,6081 –19–31MAR00–1/2 32 3260 19