John Deere 700H Crawler Dozer — Inspect Metal Face Seals

Track System Inspect Metal Face Seals 1. Inspect for the following conditions to determine if seals can be reused: The narrow, highly polished sealing area (E) must be in the outer half of seal ring face (D). Sealing area must be uniform and concentric with the ID and OD of seal ring (A). Sealing area must not be chipped, nicked, or scratched. A—Seal Ring B—Worn Area (shaded area) C—Seal Ring Face D—Outer Half of Seal Ring Face E—Sealing Area (dark line) T85079 –UN–24AUG93 TM1859 (14JUL04) 01-0130-15 700H Crawler Dozer Continued on next page T47,0130,5939HQ –19–25AUG93–1/3 071404 PN=65 NOTE: A volatile, non-petroleum base solvent or talcum powder may be used as a lubricant. 18.

Wipe both metal seal ring faces dry with a lint-free tissue. 19. Apply a thin film of oil, as used in the roller, to the shiny sealing area on both metal seal rings. 20. Install seal retainer (C) and snap ring (D) on roller shaft. 21. Fill roller with clean oil. (See Opertor’s Manual.) Carrier Roller—Specification Carrier Roller Oil—Capacity.............................................. 356 mL (12 oz) 22. Install cover (I) and cap screws (H). Tighten cap screws to specification. Carrier Roller—Specification Carrier Roller Cover Cap Screws—Torque.............................................................. 47 N•m (35 lb-ft) CED,TX03399,5938 –19–24MAR00–3/3 01 0130 15