John Deere 700H Crawler Dozer — Adding Oil To The Roller

Track System Adding Oil To The Roller 1. Thoroughly clean nozzle (1), from JD313A Front Idler Lube Nozzle Kit, and around the plug end of track roller shaft. 2. Insert nozzle in roller shaft with flat side up, as far as possible. This will allow bleeding of air from housing. T6090AI –UN–26OCT88 NOTE: Track roller shaft oil capacity is approximately 378.5 mL (12.8 oz). 3. Slowly pump recommended oil into shaft. (See Operator’s Manual.) Use adapter (2) and grease gun (3) until oil without air bubbles is seen leaking past the flat on nozzle.

1—JD313-1 Lube Nozzle 2—JD313-2 Adapter 3—Grease Gun CED,TX03399,5945 –19–24MAR00–1/1 TM1859 (14JUL04) 01-0130-27 700H Crawler Dozer 071404 PN=77 Test Track Roller for Leakage 1. Remove plug from track roller. 2. Fill track roller with recommended oil. (See Operator’s Manual.) –UN–26OCT88 3. Turn roller several times to seal metal face seals. 4. Assemble parts (1—6) as shown. T80613 5. Pressurize roller with compressed air to specification and close valve (5). 1—JTO5494 O-Ring Fitting (7/16 -20 M 37° x 3/4 Specification -16 M ORB) Track Roller Leakage Test—Air 2—JTO3001 Tee Fitting (7/16 -20 M 37° x 7/16 -20 Pressure................................................

117 ± 10 kPa (1 ± 2 bar) (17 ± 3 F 37° Sw x 7/16 -20 M 37°) psi) 3—JTO3017 Pressure Hose 4—Pressure Gauge 689 kPa (6.89 bar) (0—100 psi) 6. Track roller must maintain air pressure for two minutes. 5—JTO3087 Snubber Valve Oil must not leak past metal seals or O-ring. If oil leaks 6—Regulator with Gauge past seals, repair as necessary. 7. Install O-ring and tighten plug. TX,0130,SS2438 –19–13JUN95–1/1 01 0130 27