TCD 2015 Drive system I 02-03-03 Insert the bottom part of the assembly tool (3) into the removal gauge from below. Place the connecting rod (1) on the base plate. 1 The flat side (arrow) of the connecting rod must face down. 2 Turn the bottom part (3) into the top part (2) of the as- sembly tool. 3 6 © 40403-0 Align the top part (1) of the assembly tool and remov- al gauge (2). The top part of the assembly tool and the removal gauge are level with the angled surfaces (arrows) of the big end bearing. 1 2 © 40401-0 Screw the top part (1) and bottom part (2) of the as- sembly tool together. 1 2 © 40402-0 © 06/2006 8168-001 2/6