Komatsu — CHECK BEFORE STARTING ENGINE, ADJUST

. OPERATION OPERATION ADJUSTMENT SEAT ADJUSTMENT WARNING (A) Fore-and-aft adjustment Move lever (1) up and move the seat to the desired position and release the lever. Fore-and-aft adjustment: 210 mm (10 mm x 21 stages) (8.3 in (0.4 in) x 21 stages) Forward tilt: 3 degrees Rear tilt: 11 degrees (C) Adjusting seat height The seat height adjustment uses an air system, and it can be 3 - 85 Park the machine in a safe place and stop t he engine when carrying out adjustment of the operator Adjust th e seat position at the beginning o f each shift or when operators change.

Adjust th e seat so that the brake pedal can be depressed all the way down with the operator's back An air com pressor built into the seat is us ed for adjustment (C) and (D), so turn the engine st arting switch to the ON position be fore starting the adjustment. NOTICE There is dan ger of damage to the air compres sor, so do not keep lever (3) operated continuously for m (B) Adjusti ng seat angle Move lever (2) up, move the seat cushio to set to th e desired position, then releas Amount of adjusted st When adju fully (when is set at th pulling it up, pull it until a clic e desired height, release the l pulled up, t he position where the seat do the maxim um height.

When the seat height, the suspension automatically goe the amoun t of movement of the lever. If the opera tor raises his body from the se at or changes the amount of weight applied to the s eat during adjustment, the air in th e suspension may be dischar ged. Amount of adjustment: 80 mm (3.2 in) REMARK If lever (3) i s pulled up further from the ma ximum height, the air compressor may make a sou nd of actuation but the seat may n ot rise. This does not indicate If this happ pushed do