. OPERATION LONG-TERM STORAGE LONG-TERM STORAGE DURING STORAGE WARNING AFTER STORAGE 3 - 156 BEFORE STORAGE ore than one month), store as follows. When keeping in long-term storage (m Clean and wash all parts, then store the machine indoors. If the machine has to be stored o utdoors, select l evel ground and cover the machine with a sheet. revents moisture from collecting. storage. draulic cylinder piston rod with grease. of the battery and cover it or remove it from the machine and store it k lever. to give a density of at least 30% for the engine coolant. Completely fill the fuel tank.
This p Lubricate and change the oil before Coat the exposed portion of the hy Disconnect the negative terminals Lock each control lever with the loc To prevent rust, fill with COOLANT to give a density of at least 30% for the engine coolan If it is necessary to perform the rust-preven tion operation while the machine is indoors, open the doors a nd windows to improve ventilation and prevent gas poisoning. During storage, operate and move the machine for a short distance once a month so that a new film of oil will coat moving parts. At the same tim e, also charge the battery. nt, wipe off all the grease from the hydraulic cylinder rods.
When operating the work equipme nt, wipe off all the grease from the hydraulic cylinder ro If the machine is equipped with an air conditioner, operate the air conditioner for 3 to 5 m inutes once a month to lubricate all parts of the air cond addition, check the refrigerant level itioner compressor. Always run the engine at low idle when doing this. In twice 1 year. idle when doing . In NOTICE If the machine has been stored without ca rrying out the monthly rust-prevention operation, consult yo ur Komatsu d istributor before using it. When using the machine after long-te rm storage, do as follows before using it. ulic cylinder rods. points.
Wipe off the grease from the hydra Add oil and grease at all lubrication When the machine is stored for a lo ng period, moisture in the air will mix with the oil. Che ck the oil before and after starting the engine. If there is water in the oil, change all the oil.