Komatsu — METHOD OF TOWING MACHINE

. OPERATION TROUBLESHOOTING 3 - 159 This machine must not be tow ed except in emergencies. When towing the machine, take the followin g precautions. Before releasing the brake s, put blocks under the wheels to prevent the machine from moving. If the wheels are not blocked, the machine may suddenly move. When towing a machine, to w it at a low speed of less than 2 km/h (1.2 MPH), and for a distance o f a few meters to a place where repairs ca n be carried out. The machine should be to wed only in emergencies. If the machine must be moved long dista nces, use a transporter. he same class as the machine being towed.

Use a towing machine of t he same class as the machine being towed Check that the towing mac hine has ample braking power, weight, and ri m pull to allow it to control both machines on slopes or on the tow ro ad. in for both the towing machine and the machine being towed. the towing wire or towing bar breaks, install protective plates on both the towing being towed. ng wire as small as possible. e center lines of the two machines to within 30 degrees.

Use the specified towing p in for both the towing machine and the mac To protect the operator if machine and the machine Keep the angle of the towi Keep the angle between th e center lines of the two machines to withi When towing down a slope , use two towing machines. One machine s hould be uphill from the dis abled machine and should be connected with towing wire or a drawbar to pull the di tow the disabled machine downhill. The other machine should Towing may be carried ou requirements for towing.

Towing on flat horizontal r surfaces will require the m WHEN ENGINE RUNS If the transmission and st eering wheel can be operated, and the engine is running, it is possible to tow the move it for a short distance to the edge of the road. machine out of mud or to move it for a short distance to the edge of th The operator should sit on the machine being towed and operate the steering in the direction th at the machine is towed. WHEN ENGINE DOES NO T RUNS the engine stopped, use the following procedure. s not lubricate the system, so remove the front and rear drive shafts. If necessary, the machine from moving. perated, so remove the steering cylinder.

When towing a machine with the engine stopped, use the following proc 1. The transmission oil doe block the tires to prevent 2. The steering cannot be o Even if the brakes are in change in the operating depressed. good condition, the brakes can only be use d a limited number of time s. There i s no force for the brake pedal, but the braking force is reduced each time the pedal is is 3. Connect the towing equip ment securely. When carrying out towing operations, use two mach ines of at l east the same class as the ma being towed, then remov chine being towed. Connect one machine each to the front and rear of the machine e the blocks from the tires and tow the mac 4.

Parking brake The parking brake canno nt be turned OFF. To release the parking b