Komatsu — OTHER TROUBLE

. OPERATION TROUBLESHOOTING Transmission Axle Disc brake Parking brake 3 - 166 CHASSIS ( ) : Always contact your Komatsu distributor when dealing with these items. In cases of problems or causes which are not listed below, contact your Komatsu distributor for repairs.

Problem Main causes Remedy Engine is running but machine does not move Parking brake is applied Directional switch is not operated properly Lack of oil in transmission case Release parking brake Operate switch properly Add oil to specified level, see WHEN REQUIRED Even when engine is run at full throttle, machine only moves slowly and lacks power Lack of oil in transmission case Transmission strainer is clogged Add oil to specified level, see WHEN REQUIRED ( Disassemble, clean) Oil overheats Too much oil or too little oil Machine is not traveling in correct speed range Torque converter is stalled for long periods Engine is overheating Add or drain oil to specified level, see WHEN REQUIRED Place in correct speed range Reduce stall time ( Check engine) Noise generated Lack of oil Add oil to specified level, see WHEN REQUIRED Noise generated Lack of oil Add oil to specified level, see WHEN REQUIRED Brake has no effect even when pedal is depressed Disc has reached wear limit Defective hydraulic system Lack of oil Air in brake line ( Replace disc) Add oil to specified level, see CHECKS BEFORE STARTING Bleed air.

See WHEN REQUIRED Brake drags or remains applied Vent in valve clogged Defective operation of brake valve Defective operation of slack adjuster Clean ( Check, repair) ( Check, repair) Brakes slip Worn disc ( Replace) Brake effect is poor Linkage is loose Pad is wet Deteriorated air cylinder spring Worn pad Adjust Clean ( Replace spring) Adjust or replace