Komatsu — OTHER TROUBLE

. OPERATION TROUBLESHOOTING 3 - 168 ENGINE ( ) : Always contact your Komatsu distributor when dealing with these items. In cases of problems or causes which are not listed below, contact your Komatsu distributor for repairs.

Problem Main causes Remedy Engine oil pressure caution appears on CGC monitor Engine oil pan level is low (sucking in air) Clogged oil filter cartridge Defective tightening of oil pipe, pipe joint, oil leakage from damaged part Defective pilot lamp Add oil to specified level, see CHECK BEFORE STARTING Replace cartridge, see EVERY 250 HOURS SERVICE ( Check, repair) ( Replace) Steam is emitted from top part of radiator (pressure valve) Cooling water level low Loose fan belt Dirt or scale accumulated in cooling system Clogged radiator fin or damaged fin Defective thermostat Loose radiator filler cap (high altitude operation) Defective pilot lamp Add cooling water, repair, see CHECK BEFORE STARTING Adjust fan belt tension see EVERY 250 HOURS SERVICE Change cooling water, clean inside of cooling system, see WHEN REQUIRED Clean or repair, see WHEN REQUIRED ( Replace thermostat) Tighten cap or replace packing ( Replace) Engine water temperature caution appears on multi monitor Engine does not start when starting motor is turned Lack of fuel Air in fuel system Defective fuel injection pump or nozzle Starting motor cranks engine sluggishly Defective compression Defective valve clearance Add fuel, see CHECK BEFORE STARTING Repair place where air is sucked in ( Replace pump or nozzle) See ELECTRICAL SYSTEM ( Adjust valve clearance) Lubricating pressure does not rise when prelube motor is operated Defective prelube motor ( Replace) Exhaust gas is white or blue Too much oil in oil pan Improper fuel Add oil to specified level, see CHECK BEFORE STARTING Change to specified fuel