Komatsu — GUIDES TO MAINTENANCE

. MAINTENANCE GUIDES TO MAINTENANCE 4 - 3 DUSTY WORKSITES: do as follows: monitor frequently to see if the air cleaner is clogged. a shorter interval than specified. ly to avoid clogging. frequently. pecially the starting motor and alternator, to avoid accumulation of dust. When working at dusty worksites, Inspect the air cleaner clogging monitor frequently to see if the air c leaner is Clean the air cleaner element at Clean the radiator core frequent Clean and replace the fuel filter Clean electrical components, es pecially the starting motor and alternator, to avoid accumulation of dust.

When inspecting or changing the oil, move the machine to a place th at is free of dus t to prevent di rt from g etting into the oil. AVOID MIXING OIL: If a different brand or grade of oil ha s to be added, drain the old oil and r eplace all t he oil with the new b rand or grade of oil. Never mix different brand or grade of oil. LOCKING INSPECTION COVERS: Lock inspection cover securely int o position with the lock bar. If inspection or maintenance is performed with Lock erforme inspection cover not locked in posit ion, there is a danger that it may be suddenly blow shu t by the wi nd and cause injury to the worker. BLEEDING AIR FROM HYDRAULIC CIR CUIT:

e been repaired or replaced and if the hydraulic hoses, pipes, etc. have been If t he hydraulic oil equipments hav the hydra ulic hoses tc. have been disconnected, it is necessary to ble ed air from the circuit. See "CHAN GE OIL IN HYDRAULIC TAN K, REPLACE HYDRAULIC FILTER ELEMENT ( PAGE 4-70)". PRECAUTIONS WHEN INSTALLING HY DRAULIC HOSES: ns where there are O-rings or gasket seals, clean the mounting surface, and o forget to assemble the O-rings and gaskets. When removing parts at locatio replace with new parts. When doing this, be careful not t o forget to assemble the O-rings a nd gasket When installing the hoses, do no t twist them or bend them sharply.

If they are installed so, their s ervice li fe will be shortened extremely and the y may be damaged. clean the mounting CHECKS AFTER INSPECTION AND MAI NTENANCE: If you forget to perform the checks after inspection and maintenance, unexpect ed problems may o ccur, an d this may l ead to serious injury or prope rty damage. Always do the followin Checks after operation (with eng Have any inspection and mai Have all inspection and main Have any tools or parts been dropped inside the machine? It is particular ly dangerous i f part s are dr opped inside the machine and get c aught in the lever linkage mechanis Are there any leakage of coo lant or oil? Have all nuts and bolts been tightened?

Check when the engine is runni See "TWO WORKERS FOR MAINTENANCE WHEN ENGINE IS RUNNIN G (PAGE 2-39)" in t he secti on on safety for checking when the engine is running. Pay attention to Check if the inspected and m aintenance area is operating norm Increase the engine speed to