Komatsu — HANDLING OIL, FUEL, COOLANT, AND PERFORMING OIL CLINIC

. MAINTENANCE OUTLINES OF SERVICE 4 - 5 FUEL To prevent the moisture in the air from co ndensing and forming water inside the fuel tank, always fi ll the fuel t ank after completing the day's work. and if fuel containing water or dirt is used, it cannot work properly. get in when storing or adding fuel. ration and Maintenance Manual. perature when it is used (particularly in low temperatures below -15° el that is suitable for the temperature.

The fuel pump is a precision instrument, and if fuel containing water or dirt is used, it cannot wor k properly Be extremely careful not to let impurities Always use the fuel specified in the Ope Fuel may congeal depending on the tem C (5°F)), so it is necessary to use the fu Before starting the engine, or when 10 mi nutes have passed after adding fuel, drain the sediment a nd water f rom the fuel tank. If the engine runs out of fuel, or if the filte rs have been replaced, it is necessary to bleed the air fro m the circuit. If there is any foreign material in the fuel tank, wash the tank and fuel system. -15 ° NOTICE . Always use diesel fuel.

Never use any other fuel The engine on this machine uses electronic cont rol and high-pressure fuel injection equipment to enable it to pr ovide good fuel consumption and good exhaust gas characterist ics. For this reason, high-precision parts and lubricating ability are demanded. Using low-viscosity fuel with poor lubricating ab ility will cause a marked reduction in the durability of the engin e. COOLANT AND WATER FOR DILUTIO N F-NAC) has the important function of preventing corrosion as well as an issue, the use of antifreeze COOLANT is essential. omatsu SUPERCOOLANT (AF-NAC). SUPERCOOLANT (AF-NAC) Komatsu genuine SUPERCOOLANT (A preventing freezing.

Even in the areas where freezing is not Komatsu machines are supplied with K omatsu SUPERCOOLANT (AF-NAC). SUPERCOOLA has excellent anticorrosion, antifreeze a 4000 hours. nd cooling properties and can be used continuously for two years or s strongly recommended wherever available. rs according to the ambient temperature. NT, see "CLEAN INSIDE OF COOLING SYSTEM (PAGE 4-23)".

Komatsu SUPERCOOLANT (AF-NAC) i The density used for the COOLANT diffe For details of the density of the COOLA NT, see "CLEAN INSIDE OF COOLING SYSTEM (PAG Even in the areas where it is not consider ed necessary to prevent freezing, always use COOLANT with a density of over 30% in order to prevent corrosio n of the cooling system. pplied already mixed. In such cases, never dilute with water. ater or tap water (soft water). well water (hard water), contains large amounts of minerals (calcium, SUPERCOOLANT (AF-NAC) may be su pplied already mixed.

In such cases, never dilute with w When diluting the coolant, use distilled w Natural water, such as a river water or magnesium, etc.), and this makes it easie r for scale to form inside the engine or radiator. Once scal e is deposited inside the engine or radiator, it is extre mely difficult to remove. It also causes overheating due to poor heat exchange, so when you dilute the coolan t, we recommend that you use water with an overall har dness of less than 100 PPM. the precautions given in the Operation and Maintenance Manual. re to keep it away from flame. ne to cool before adding coolant. When using antifreeze, always observe the precautions given in the Operation and Maintenance Manual.

Undiluted coolant is flammable, so be su If the engine overheats, wait for the engi If the coolant level is low, it will cause over heating, and will also cause problems with corrosion due to air entering the coolant.