Komatsu — EVERY 2000 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE container under drain plugs (8) and (9) of circuit of the axle final drive to catch the oil. (Approx. 50 liters (13.2 US gal) of oil will come out from each drain plugs (8) and (9), and drain the oil from the 4 wheels (front, rear, left, and right). 7. After draining the oil, tighten plugs (8) and (9). Tightening torque: 58.8 to 78.4 Nm (6 to 8 kgm, 43.4 to 57.9 lbft). 4 - 78 5. circuit (Appro wheel. Loose the cooling 8. Replac e the filter element. For d etails, see REPLACE BRAKE OIL FI LTER ELE MENT (PAGE 9.

Add th e specified amount of eng ine oil through oil fillers (F) to the sp ecified leve l in both tanks, then install plugs (2) and (3) 10. 11. in the Install Start t center of th the oil filler he engine a e filter cover. caps. nd bleed the air from the circuit. For details, see B (PAGE LEEDING A 4-36). IR FROM BRAKE HYDRAULIC CIRCUIT 12. Idle th e engine for a short time, t hen check that the oil is at t he specifi ed level. F or details, see CHECK BRAKE OIL TANK BRAKE OI TANK LEVEL , ADD OIL (PAGE 3-81).