Komatsu — EVERY 2000 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE REPLACE BRAKE OIL TANK BREATHER WARNING engine is stopped, and may cause burns. Wait for the CHECK ACCUMULATOR FUNCTION Check the gas pressure of the accumulator as follows. 4 - 80 T he parts and oil are at high t emperature to go down before W hen removing the oil filler ca p, turn it slowly to release the internal 1. Remove the cap of oil fille r (F). ther (1), then remove breather ca 2. Remove nut (2) from brea (3). 3. Replace filter element (4) w ith a new part, then install breath cap (3) and tighten nut (2) . .33 kgm, 2.0 to 2.4 lbft) (F). Tightening torque: 2.65 to 3.24 Nm (0.27 to 0 4.

Tighten the cap of oil filler REMARK I t is possible to replace the el ement with the breather installed the ather is removed, do not wrap th with seal tape when assemblin hten too much. again, and be careful not to tig CHECKING ground and apply the parking brake. to the maximum height, then place the lift arm control lever at HOLD. t in this position, and stop the engine. nd the machine, then set the lift arm nd lower the work equipment to a the ground. t reaches a position 1 m (3.28 ft) e lift arm control lever to LOWER, ent slowly to the ground. s moving during checking, the gas e service limit (0.69 MPa (7 kg/cm2, ur Komatsu distributor to have the gas charged. 1. 2. 3. 4. 5. 1.

Stop the machine on level ground and apply the parking br ake. 2. Raise the work equipment to the maximum height, then pla ce the lift arm control lever 3. Leave the work equipmen t in this position, and stop the eng ine. 4. Confirm that it is safe arou nd the machine, then set the lift ar control lever at FLOAT a nd lower the work equipment to the ground. t reaches a position 1 m (3.28 e lift arm control lever to LOWE ent slowly to the ground.

position 1 m (3.28 ft) from When the work equipmen from the ground, move th and lower the work equipm If the work equipment stop pressure may be below th 99.4 PSI)), so contact yo gas pressure measured or Carry out the checks within fiv e minutes of stopping the engine. If the machine is left with t he engine stopped, the accumulator pressure will dro p and it will be impossible to carry out the check.