Komatsu — BATTERY

. SAFETY PRECAUTIONS FOR OPERATION BATTERY If you spill acid on your clothes or skin, immediately flush the area with large amount of water. If acid gets into your eyes, flush them immediately with large amount of water and seek medical attention. Before working with batteries, turn the starting switch to the OFF position. 2 - 33 BATTERY HAZARD PREVENTION Battery electrolyte contains sulphuric acid, and batteries generate flammable hydrogen gas, which may explode. Mistaken handling can lead to serious injury or fire. For this reason, always o bserve the following precautions. Do not use or charge the battery if the battery electrolyte level is below the L OWER LEVEL line.

This may cause an explosion. Check the battery electrolyte level periodically and add distille to the UPPER LEVEL line. d water to bring the electrolyte level es. When working with batteries, always wear safety glasses and rubber glov Never smoke or use any flame near the battery. As there is a hazard that sparks will be generated, always do as follows. Do not let tools or other metal objects make any contact between the batt other metal objects lying around near the battery. Always disconnect the negative (-) terminal (ground side) first when remo ery terminals. Do not leave tools or ving the battery; when installing the .

ing the battery cables, first turn the battery, connect the positive (+) terminal first, and connect the ground last For the machine with battery disconnect switch (if equipped), when remov starting switch to the OFF position, wait over one minute, then turn off the out the battery disconnect switch key. Then, begin the cable removal at the ground (negative (-)) cable side. When to begin with the positive (+) cable side and finish at the ground cable side battery disconnect switch, and take installing the battery cables, be sure . Attach the battery terminal securely.

Flammable hydrogen gas is generated when the battery is charged, so remo ve the battery from the chassis, take it to a well-ventilated place, and remove the battery caps before charging i t. Tighten the battery caps securely. Install the battery securely to the determined place.