Komatsu — SWITCHES

. OPERATION EXPLANATION OF COMPONENTS RPM SET IDLE UP-DOWN SELECTOR SWITCH CAUTION Position (a): raising speed 3 - 35 If the RPM SET ON-OFF sw itch or engine starting switch are tur ned OFF, the idle up and idl e down speeds are clea red from memory. To set the values again, repeat the operation from the beginning. When the values have been set with the RPM SET idle up-down selector switch, if the right brake pedal is depress ed when waiting for adump truck, the is pressed again, the engin engine speed stored in memory will go down to the idling speed, b ut when portion (b) of th e switch e will return to the original speed.

To actuate the switch, chec k that the RPM SET ON-OFF switch is at the ON position. If it is at the ON position, the i ndicator lights up. Use this switch (14) to hold the engine at the desired spee Use this position when set the set engine speed. When using the acceler Depress the accelerato rises to the desired set The engine speed at tha speed, press portion (a) of the s t point is set and saved to mem When using the RPM se t idling up/down switch Keep portion (a) of the s the desired speed, relea witch pressed for at least 0.5 sec to raise the engine spee d. When the engine r eaches se the switch. The new speed i s recorded to memory an d the setting is made . Position (b):

ering the engine speed or when resetting after canceling the RPM set switch. t up/down switch Use this position when low ering the engine speed or when resetting after canceling t When using the RPM se Keep portion (b) of the s the desired speed, relea witch pressed for at least 0.5 sec to lower the engine spee d. When the engine r eaches se the switch. The new speed i s recorded to memory an d the setting is made REMARK Setting the engine spe necessary when carryin cycle time for operation g out operations with the accelerator, so the engine acce When traveling in load reduced.

When resetting the engi ne speed to the desired speed w ithout using LOWER posi tion (b) of the RPM s et idling up/down selector switch to raise the engine spee The new speed is recor , depress the right brake pedal t o cancel the set speed, th en use the accelerato r pedal d. When the engine reaches th e desired speed, press S ET position (a) of the switch. ded to memory and the setting i s made.