. OPERATION EXPLANATION OF COMPONENTS head of the joystick steering between FORWARD and REVERSE. Position (a): FORWARD (F) Position (b): Neutral (N) Position (c): REVERSE (R) When shifting the speed range, use the shift up and shift down ON: Lamp lights up OFF: Lamp goes out 3 - 39 DIRECTIONAL SELECTOR SWITCH Use directional switch (22) at the lever to switch FRONT WORKING LAMP SWITCH Press this button (23) to turn the fro nt workin g lamp s (fro nt working lamp at side of c ab, front working l p) ON and OFF. amp on axle, working lamp at orkin side of head lam When the switch is pressed once, t he pilot l amp li ghts u p and the working lamp is t urned ON.
When t he switch is pressed again , the pilot lamp goes o ut and the workin g lamp is turne d OFF . ON: Lamps light up (front workin g lamp at sid e of cab, f ront working lam p on axle, working lamp at side o f hea d lam OFF: Lamps go When turning on the front working la mps, se t to the side clearance lamp ON positio n or head lamp O N positi on, th en op erate switch. If the s witch is not in on ill not light up. above working lamps w REAR WORKING LAMP SWITCH Press this button (24) to turn the re ar workin g lam p ON and O FF. When the switch is pressed once, t he pilot l amp li ghts u p and the working lamp is t urned ON.
When t he switch is pressed again , the pilot lamp goes o ut and the workin g lamp is turne d OFF . When turning on the rear working l amp, set to the side clearance lamp ON positio n or head lamp O N positi on, th en op erate switch. If the s above working lamp wil