Komatsu — WELDING BODY PROTECTOR

43 HD325, 405-6 Order of work Work procedure (5) Weld the protector. (See page 38, 39.) • Welding order: Weld the side plate first. • Welding symbol: Shown in the weld- ing instruction drawing. • Welding condition: Shown in weld- ing condition table on the previous page. • Perform welding according to KES04.343, General, 2nd Grade. (6) Finishing Remove the spatters and finish the beads with a grinder. Cut the hanging plate welded to the top of the body with gas and finish the marks of weld with a grinder. (7) Check the welded parts for defects.

1 Crack of weld bead (visual check) 2 Undercut, overlap, and spatter 3 Leg length of weld for shortage (In- sufficient leg length is not permitted.) (8) After cooling, paint the welded parts. 1 Mix the base and hardener of the paint well at the ratio of 5:1 as speci- fied. 2 After painting, clean the paint spray gun with paint thinner before the paint is hardened. [Undercoat paint] RETAN GP primer RETAN GP hardener RETAN GP thinner [Top coat paint] NAX MIGHTYLAC II KB natural yellow NAX MIGHTYLAC II KB hardener NAX MIGHTYLAC II KB thinner • Apply CO gas shielded arc welding as stan- 2 dard. If it is difficult to apply, however, apply arc welding.

• Drying time of arc welding rod (1) Temperature: 150 – 200ºC (2) Time: 120 minutes • Put on mask, goggles, gloves, etc. to protect yourself from paint mist.