47 HD325, 405-6 Order of work Work procedure 1. Set the right side of the split body on the stand. 2. Set the left side of the split body on the stand so that the clearance will be even. 3. Secure the body with the following parts, uti- lizing plates 566-83-6H190 (at 5 places). (See page 52, 53.) 01011-82010, Bolt, 5 pieces 01643-32060, Washer, 5 pieces 01580-12016, Nut, 5 pieces 581-74-11630, Tube, 5 pieces 4. Adjust the large end of the bottom plate, large end of the front plate, and ribs flush with each other. 5. Secure the body by tack welding. 6.
Remove the cross ribs (7 pieces) tack-welded to the bottom plate and install them by tack welding, matching them to the ribs of the bottom plate. When installing the ribs, re- move the mudguard mounting plate (566-74- 6EB90, Plate). • If both sides are not matched accurately, ad- just them with hydraulic cylinders. • When setting the right side, utilize the hang- ing plate on the underside of the side plate and the exhaust port. • If the split parts are deviated from each other excessively, correct them with hydraulic cyl- inders. • When correcting them, check that the mount- ing bolts are loosened.