Komatsu — FIELD ASSEMBLY INSPECTION REPORT

3/4 No. Inspection item Judgment procedure and standards Check Mainte- nance Remarks 17 Shock made when dump body is lower to end When dump body is seated, unpleasant shock must not be made. (Sensory check) 18 Function of body positioner (Overseas OP.) Operate lever to RAISE position and check that it does not return to HOLD when released. Operate lever to RAISE position to raise dump body and check that it automatically returns to HOLD at a point 50 – 100 mm before end of H/T cylinder stroke. 19 Alignment of dump body on right and left When dump body is raised fully, it must not sway to right or left. (Difference in dimension between right and left hoist cylinders: Max.

7 mm) When dump body is lower fully, it must come in contact with mount evenly. (Contact area must be at least 80%.) When dump body is lower fully, it must come in contact with vibration stopper evenly. 20 Body lifting speed (Oil temperature: 80ºC) Engine speed: Rated speed (2000rpm) Standard common to HD325 and 405: 10.5 ± 1.5 sec, Mea- sured value: ( ) sec 21 Body lowering speed (Lever at FLOAT,Oil tempera- ture: 50 – 70ºC) Engine speed: Low idling speed (650rpm) Standard (HD325): 11.0±1.5 sec, Measured value:( )sec Standard (HD405):

15.0±1.5 sec, Measured value:( )sec 22 Function of dump body opera- tion caution lamp Must light up when dump lever is set to any position other than FLOAT or while dump body is not seated. * Centralized warning lamp and warning buzzer must not operate. 23 Hydraulic drift of dump body Hydraulic drift in 5 minutes must be 85 mm or less. (From point where cylinder No. 2 is extended by 100 mm), Mea- sured value: ( ) mm 24 Function of lifting dump body with emergency starting motor Stop engine and check that dump body can be lifted with emergency steering motor. * Do not operate emergency steering motor for more than 90 seconds continuously. Stop truck on level ground and measure.

25 Length of suspension cylinder (Front) * Measure with dump body empty. Length must be shorter than dimension A. Dimension A: 233 (Position of label) ± 10 mm Measured value: Left ( ) mm, Right ( ) mm 26 Length of suspension cylinder (Rear) * Measure with dump body empty. Length must be shorter than dimension A. Dimension A: 191 ± 10 mm Measured value: Left ( ) mm, Right ( ) mm 27 Automatic suspension control function (Opt.) Measure with dump body empty. 1 When dump lever is set to any position other than FLOAT, display must change from [Soft] to [Hard]. 2 When service brake or emergency brake is turned ON, display must change from [Soft] to [Medium].

3 Display must show [Soft] in all cases other than 1 and 2 above. Inspect each part. 28 Function of safety pin Safety pin must be inserted without obstruction in right and left stopper holes. 29 Storage function of safety pin Safety pin must be removed from, installed to, and locked at storage position securely. 30 Installation of dump control linkage Locknut must not be loosened. Boots (Rubber covers) of cable must not be twisted. (At right side of cab, hoist valve, and positioner)