. OPERATION OPERATION ADJUSTMENT SEAT ADJUSTMENT WARNING Amount of adjustment: 50 mm (2.0 in) (D) Setting seat for weight 3 - 99 When adjusting the position of the operat or's seat, alwa ys set the work equipment loc k lever to the LOCK position to preven t any accidental contact with the control levers . Always adjust the operator's seat before startin g each operation or when the oper ators change s hift. When adjustin g the seat, put your back against the backrest and adjust t o a positi on where the br ake peda l can be fully depres sed. AIR SUSPENSION SEAT adjustment (A) Fore-and-aft Pull lever (1) up, set the seat to the d esired positi on, then release the lever. stment:
120 mm (4.7 in) Fore-and-aft adju stment: 120 mm (4. (B) Adjusting sea t angle p and push down on the rear of the seat to tilt it Move lever (2) u backward. Move lever (2) do wn and push down on the front of the seat to tilt it forward. e: 13 degrees (Tilt forward/tilt back angle) Adjustment rang e: 13 degrees (Tilt fo rward/tilt ba (C) Adjusting hei Move lever (2) up ght of seat or down to move the seat up or down. This lever is also used to a height. Knob (3) controls the air suspension or pull the knob to a djust the suspensio n's strength a nd compensate for operator weig ht and/or preference . (E) Adjusting rec lining angle Move lever (4) up and move the backrest to the fr ont or rear.
Adjustment rang e: Front 24 degrees , Rear 3 deg rees (F) Lumbar supp ort Turn grip (5) to a djust the tension ap plied to the lo wer back. (G) Adjusting he adrest height st (6) up or down. Move the headre Amount of adjust ment: 50 mm (2.0 in