Index Section 130 UENR4490-01 Alignment of the Flywheel Face ...................... 118 Flywheel Runout............................................ 119 Flywheel Housing - Inspect ................................ 119 Alignment of the Flywheel Housing.................. 119 Concentricity of the Flywheel Housing .............
119 Fuel Injection ......................................................40 Fuel Injectors...................................................47 Fuel Manifold...................................................48 Fuel Pump Assembly .......................................44 Introduction .....................................................40 Primary Filter/Water Separator..........................44 Secondary Fuel Filter .......................................44 Fuel Injection Timing - Check ...............................83 Fuel Quality - Test ...............................................84 Fuel System .......................................................80 Fuel System - Inspect..........................................80 Fuel System - Prime............................................85 Inspection of the Compressor and the Compressor Housing.........................................................89 Inspection of the Turbine Wheel and the Turbine Housing.........................................................90 Inspection of the Wastegate..............................90 Turbocharger - Inspect (Single Turbocharger) .......91 Inspection of the Compressor and the Compressor Housing.........................................................92 Inspection of the Turbine Wheel and the Turbine Housing.........................................................93 Inspection of the Wastegate..............................93 V V-Belt - Test ......................................................125 Poly V-Belt ....................................................125 Valve Depth - Inspect...........................................97 Valve Guide - Inspect...........................................98 G Gear Group - Inspect.........................................120 Gear Group (Front) - Time ...................................86 General Information ..............................................4 Glossary of Electronic Control Terms ....................74 W Water Pump - Inspect ........................................
113 Water Temperature Regulator - Test ................... 113 I Important Safety Information..................................2 Increased Engine Oil Temperature - Inspect ........109 Introduction ..........................................................4 1204F-E44TA Engine with Single Turbocharger ...8 1204F-E44TTA Engine with Series Turbochargers .................................................5 L Lubrication System...................................... 37, 107 P Piston Height - Inspect....................................... 117 Piston Ring Groove - Inspect.............................. 114 Inspect the Clearance of the Piston Ring .........
115 Inspect the Piston and the Piston Rings........... 114 Inspect the Piston Ring End Gap..................... 115 Position the Valve Mechanism Before Maintenance Procedures .................................
114 Power Sources ...................................................69 ECM Power Supply..........................................70 Introduction .....................................................69 Power Supply for the Diesel Exhaust Fluid (DEF) Dosing Control System...................................73 Power Supply for the Glow plugs.......................72 Power Supply for the Pressure Sensors.............71 S Systems Operation Section....................................4 T Table of Contents ..................................................3 Testing and Adjusting Section ..............................80 Turbocharger - Inspect (Series Turbochargers)......88