Perkins — Perkins 1204F-E44TA and 1204F-E44TTA Industrial Engine Systems Operation Manual

Engine Operation 38 UENR4490-01 Starting Motor The starting motor turns the engine via a gear on the engine flywheel. The starting motor speed must be high enough in order to initiate a sustained operation of the fuel ignition in the cylinders. The starting motor consists of the main armature and a solenoid. The solenoid is a relay with two windings Pull-In (PI) and Hold-In (HI). Upon activation of ignition switch, both windings move the iron core by electromagnets. The linkage from the iron core acts to move the pinion toward the flywheel ring gear for engagement.

Upon complete engagement, the solenoid completes the high current circuit that supplies electric power to the main armature in order to provide rotation. During cranking of the engine, only the Hold-In (HI) winding is active. The ignition switch is deactivated once the desired engine speed has been achieved. The circuit is disconnected. The armature will stop rotating. Return springs that are located on the shafts and the solenoid will disengage the pinion from flywheel ring gear back to the rest position. The armature of the starting motor and the mechanical transmissions may be damaged if the increases in the speed of the engine are greater than the pinion of the starting motor.

Damage may occur when the engine is started or after the engine is started. An overrunning clutch prevents damage to the armature of the starting motor and mechanical transmissions. Illustration 31 g01964824 Typical example 12 V 4 kW Starting Motor (1) Terminal 30 for connection of the battery cable (2) Terminal 50 for connection of ignition switch (3) Terminal 31 for connection of the ground Certain higher powered starting motors are designed with an Integrated Magnetic Switch (IMS). The Integrated Magnetic Switch (IMS) is activated by the ignition switch. The solenoid circuit then engages the starting motor.

The benefit of Integrated Magnetic Switch (IMS) is a lower current in the ignition circuit that will allow the engine ECM to control ignition without the use of a relay. Alternator The electrical outputs of the alternator have the following characteristics: Three-phase Full-wave Rectified The alternator is an electro-mechanical component. The alternator is driven by a belt from the crankshaft pulley. The alternator charges the storage battery during the engine operation. Illustration 32 g01964833 Typical example 24 V 5.5 kW Starting Motor The alternator is cooled by an external fan which is mounted behind the pulley. The fan may be mounted internally.

The fan forces air through the holes in the front of the alternator. The air exits through the holes in the back of the alternator. (4) Terminal 30 for connection of the battery cable (5) Integrated Magnetic Switch (IMS) (6) Terminal 50 for connection of ignition switch (7) Terminal 31 for connection of the ground