Komatsu — 24.1.6 REVERSE AND REPLACE THE END BITS AND CUTTING EDGES

24. SERVICE PROCEDURE 24.1.6 REVERSE AND REPLACE THE END BITS AND CUTTING EDGES It is dangerous if the work equipment moves by mistake when the cutting edges and end bits are being reversed or replaced. Set the work equipment m a stable condo- tion, then stop the engine and lock the blade control lever securely with the safety lever. c Reverse or replace the end bits and cutting edges before it is worn out to the blade end. 1. Raise the blade to a proper height and apply a block to the frame so as to prevent fall of the blade. 2. Operate the safety lever to the LOCK position. 3. Measure the wear of the end bit and cutting edge in ac- cordance with the wear standards given below.

_____ ____ --- . @@g : : : Wear standards (Unit: mm) 3 @@ @@ ::, EE! 1 Item I Judgement standard No 1 Height of outside of end bit Measurement point e pr$ent Standard dimension Repair limit A 237 204 : S, D 204 187 I D I 292 I 254 ---__ -----_____ -__,__J -_--- _______------ - E 237 204 2 Width of end bit A 325 300 I B, C I 325 I 300 / D 1 435 I 410 E 325 310 3 Height of inside of A 204 187 end bit S, C 204 187 D 254 237 E 204 187 4 Height of cutting edge (from center of bolt mounting hole to end face) A 102 85 S, D 102 85 D 127 103 E 102 85 The symbols in the work equipment column have the follow- ing meaning. A: Straight tiltdozer (D65E/D65EX) B: Straight tiltdozer (D65P/D65PX) C:

Power tilt, power pitch dozer D: Semi-U blade E: Angledozer 3-32