24. SERVICE PROCEDURE 24.1.13 CHECK DOOR LOCK STRIKER (MACHINES EQUIPPED WITH CAB) If the wear of the doors lock striker exceeds 0.5 mm, re- place the striker. If it is used at it is, the play will increase and this may result in breakage of the hinge or door lock. 24.1 .I 4 REPLACE DOOR DAMPER (MACHINES EQUIPPED WITH CAB) If the depth of the door damper rubber groove is less than 2 mm, replace the damper. There are two dampers each at the top and bottom on the left and right doors. 24.1.15 CHECK WINDOW WASHER FLUID LEVEL, ADD FLUID (MACHINES EQUIPPED WITH CAB) If there is air in the window washer fluid, check the level and add fluid.
Open the engine side cover on the right side, check the level of the fluid in window washer tank 0, and if it is low, add automobile window washer fluid. When adding fluid, be careful not to let dirt or dust get in. 24.1.16 BLEED AIR FROM HEAD END OF RIGHT PITCH CYLINDER (POWER TILT, POWER PITCH DOZER ONLY) Bleed the air if the work equipment has been removed or repaired. 1. Raise the blade and run the engine at low idling. 2. Operate the left and right tilt 5 - 10 times to bleed the air from the tilt circuit. 3. Operate the forward and rear pitch 5 - 10 times to bleed the air from the bottom end of the right cylinder. 4.
Set the left and right cylinders at the neutral position, then carry out the following operations 5 - 10 times to bleed the air from the head end of the right pitch cylinder. 0 Forward pitch - 0 Leftitilt 0 Right tilt 1 @ Rear pitch ~ 3-39