24. SERVICE PROCEDURE 24.1.18 CHECK IDLER OIL LEVEL, ADD OIL A WARNING When adding oil, if the machine is at an angle, be care- ful that it does not turn over. Be careful also when get- ting on or off the machine. In particular, be sure to use the handrails and steps when getting on or off the machine, and take other pre- cautions to ensure safety. AE072650 If the oil level in the idler is low, noise will be generated and there will be seizure, so check the oil level and add oil as follows. Checking 1. Remove bolt 0, then remove cover 0. 2. Remove bolt 0, then remove guide plate 0 and shim 0. REMARK When removing shim 0 keep it in a safe place and be careful not to lose it. 3.
Loosen plug 8 and check if oil comes out. If oil comes out the oil level is correct. If no oil comes out, drive the machine on to a block to tilt the machine. Then remove plug 8 and add engine oil through oil filler port 0. For details of the oil to use, see “20. USE OF FUEL, COOL- ANT AND LUBRICANTS ACCORDING TO AMBIENT TEM- PERATURE”. AEO72670 REMARK If it is difficult to add oil, please contact your Komatsu dis- tributor. uw AE072680 4. After adding oil, install plug 8. 5. Install guide plate 0 and shim 0 with bolt 0. REMARK When installing guide plate 0, install the same number and thickness of shim 0 as was rmeoved in Step 2.
For details of adjusting the shim thickness, see “24.1.8 AD- JUST IDLER CLEARANCE”. 6. Install cover 0 with bolt 0. 3-41