Komatsu — 24.4.3 CHECK OIL LEVEL IN FINAL DRIVE CASE, ADD OIL

24. SERVICE PROCEDURE 24.4.2 GREASE EQUALIZER BAR SIDE PIN (LEFT AND RIGHT, 2 PLACES EACH: TOTAL 4 PLACES) 1. Remove cover 0. H-T? AE072690 2. Add grease to the grease fittings marked by the arrows. REMARK When adding grease, pump in three shots (pump the grease gun lever three times) for each fitting, and check that grease is newly discharged from the seal lip. If no grease is newly discharged from the seal lip, continue to pump in grease until grease is discharged. 3. Install the cover. 24.4.3 CHECK OIL LEVEL IN FINAL DRIVE CASE, ADD OIL The oil is at high temperature immediately after the ma- IA """'""1 chme has been operated. Walt for the 011 to cool down before starting the operation.

Stop the machine so that drain plug 0 is directly at the bottom. Remove oil level plug 0 and check whether the final drive case is filled with oil to lower edge of the plug hole. If the oil level is still too low, add engine oil through the plug hole until the oil overflows. For details of the oil to use, see “20. USE OF FUEL, COOL- ANT AND LUBRICANTS ACCORDING TO AMBIENT TEM- PERATURE”. 3-51