11. EXPLANATION OF COMPONENTS - 3. GLOW SWITCH (MONITOR PANEL SPECIFICATION) This actuates the electrical heater to warm up the engine intake air. OFF position: The preheating is not actuated. AUTO position: AUTO preheating is actuated. The length of the preheating time varies according to the ambient tempera- ture when the ambient temperature is below approx. -5°C. I position: This is used when AUTO preheating is not enough to start the engine in cold weather simply with the glow switch at the AUTO position. When the switch is released, it will return to the AUTO position. II position: This is used when carrying out preheating ma- nually without using AUTO preheating.
When the switch is released, it will return to the OFF position. 4. STARTING SWITCH 1 Monitor panel specification This switch is used to start the engine. OFF ( @ ) position: At this position, the starting switch key can be inserted or removed. When the switch is turned to this position, the elec- trical circuits are switched off. Do not the starting switch key at the OFF position while the engine is running. ON position: In this position, electric current flows in the charging and lamp circuits. Keep the starting switch key at the ON position while the engine is running. START ( 0) position: This is the position to start the engine. Hold the key at this position while cranking.
Release the key immediately after the engine has been started. The key will return to ON posi- tion when released. HEAT ( 53 ) position (Gauge panel specification): 0 Turn the starting switch key to the HEAT position when starting in cold weather. Gauge panel specification HE,AT OFF I If the key is held at the HEAT position, the electrical heater is heated and the glow signal lights up or glows red. If the glow signal flashes or glows red, release the key immediately. When the key is released, it will return to OFF, so turn it im- mediately to the START position to start the engine. -START F16262 2-l 9