11. EXPLANATION OF COMPONENTS 8. BLADE CONTROL LEVER (FOR POWER TILT, POWER PITCH DOZER) This carries out the blade lift, tilt, and pitch operations. Lifting control @ RAISE : ( &_ ) @ HOLD : ( A ) Blade is stopped and held in this position. @ LOWER : ( 4 ) @ FLOAT : ( % ) Blade will m=e freely according to external force. l When released from FLOAT position, this lever will not re- turn to HOLD position, so it must be moved back by hand. REMARK l When starting the engine, set the blade control lever to the HOLD position. If it is at the FLOAT position, the engine will not start. Tilting control @ LEFT TILT : ( !& ) @ RIGHT TILT : ( 4 ) Right tilt Pitch control 8 Rear pitch:
Small blade cutting angle I Left tilt F07a% @ Forward pitch: Large blade cutting angle First set the lever to the neutral position, then keep switch 0 in the center of the knob pushed down and carry out the tilt operation to change tl ie cutting angle of the blade. Forward pitch Rear pitch *. I Precautions when using pitch control When operating the pitch, the cutting angle is shown by the gauge bar on the right pitch cylinder. When using the pitch operation, the tilt operation changes as follows. Pitch condition 1 Tilt operation 1 Amount of tilt Pitch gauge \ \ Max. forward pitch Only left tilt operation is possible Max. 890 mm Compared with standard:
Forward pitch RIGHT tilt is SMALLER LEFT tilt is LARGER Standard pitch tilt operations are Both left and right 445 mm (both left and right) Rear pitch possible Compared with standard: LEFT tilt is SMALLER RIGHT tilt is LARGER Max. rear pitch Only right tilt operation is possible Max. 890 mm 2-27