12. OPERATION CHECK OIL LEVEL IN POWER TRAIN CASE, ADDOIL 1. 2. Remove dipstick 0, and wipe the oil off with a cloth. Insert dipstick 0 fully in the oil filler pipe, then take it out again. 3. The oil level should be between the H and L marks on dipstick 0. If the oil level is below the L mark, add engine oil through oil filler 0. For details of the oil to use, see “20. USE OF FUEL, COOL- ANT AND LUBRICANTS ACCORDING TO AMBIENT TEM- PERATURE”. If the oil is above the H mark, drain the excess engine oil from drain plug @, and check the oil level again. If the oil level is correct, tighten the oil filler cap securely. 4. w 12 5. REMARK l When stopping the engine, check the oil level.
l When checking the oil level after the engine has been operated, wait for at least 15 minutes after stopping the engine before checking. If the machine is at an angle, make it horizontal before checking. CHECK BRAKE PEDAL TRAVEL 1. Depress the brake pedal all the way until it stops. 2. The distance of travel at the center of the pedal (position in the diagram on the right) should be 70 - 90 mm. 3. When this value exceeds 90 mm, or the brake fails to work, please contact your Komatsu distributor for adjust- ment. CHECK DUST INDICATOR 1. Open the engine side cover on the left side of the chassis, and check that the red piston has not appeared in the transparent portion of dust indicator 0.
If the red piston has appeared, clean or replace the ele- ment immediately. For details of the method of cleaning the element, see “24.1 WHEN REQUIRED”. After checking, cleaning, and replacing, press the knob of dust indicator 0 to return the red piston to its original po- sition. 2. 3. 2-53